V0817, 7.1
7. Settings
7.1. Introduction
The Settings mode of the control, which can be found in the navigation panel, gives access to
all kind of settings which influence the programming of new products and programs.
Default values and specific constraints can be set.
The settings are divided across several tabs logically organizing the different subjects. In the
following sections the available tabs and detailed settings are discussed.
Navigation through the tabs can be done by just tapping them and selecting the required item
to adjust. Since there can be more tabs than the screen can show in one view, dragging the
tabs in horizontal direction enables to view and select all available tabs.
By tapping the navigation button Settings the control is switched to
Settings mode.
To Next Page
Loading...
Need help?
General
