V0817, 7.10
7.4.2. Product restore
To restore programs to the control, choose ‘products’ in the Restore section on the Backup/
restore page.
When the initial restore directory has been set, the products restore screen appears.
In the restore screen the products in the selected directory are shown.
Basic functions to change the view can be chosen similarly to the Products mode. This
enables to easily find the required products to be restored.
At the top of the screen, the current restore source location is shown as well as the location on
the control to restore to. To restore a product, select it by tapping, in the list. The restore
marker will appear to confirm the restore action. If a product file with the same name is
present on the control, a question is offered whether or not to replace that file.
The source location where the products to be restored are coming from can be changed with
Restore Directory. The directory browser appears and the desired restore directory can be
navigated to.
The directory where the products which need to be restored need to go can be changed as
well. With Destination Directory the directory browser appears and the desired destination
To Next Page
Loading...
