V0817, 7.19
Default dwell time
Default value for the parameter 'dwell time' in a bend program.
Default hem opening
The hem bend can be made with a certain opening distance between the 2 flanges. The
hem opening value will be used calculating the beam position in the hemming process.
This programmed default value will be used when programming a new program in the
Program mode. The starting value is 0.0mm to get the two flanges of a hem bend
completely upon each other without any space between the flanges.
Default material
Default material, used as initial selection while starting a new program.
To Next Page
Loading...
