Dell EMC VxRail P470 - Installing a Hot Swappable Hard Drive into a Hot Swappable Hard Drive Carrier

Figure 26. Removing a hard drive from a hard drive carrier
1 screw (4) 2 hard drive
3 hard drive carrier
Next steps
If applicable, install a hard drive into the hard drive carrier.
Installing a hot swappable hard drive into a hot swappable hard
drive carrier
Prerequisites
NOTE
: Hot swappable hard drives are supplied in hot swappable hard drive carriers that fit in the hard drive slots.
1 Keep the Phillips #2 screwdriver ready.
2 Remove the hot swappable hard drive carrier.
Steps
1 Insert the hot swappable hard drive into the hard drive carrier with the connector end of the hard drive toward the back.
2 Align the screw holes on the hard drive with the set of screw holes on the hard drive carrier.
When aligned correctly, the back of the hard drive is flush with the back of the hard drive carrier.
3 Attach the screws to secure the hard drive to the hard drive carrier.
Next steps
Install the hard drive carrier into the appliance.
Figure 27. Installing a hot swappable hard drive into a hot swappable hard drive carrier
1
screw (4)
2 hard drive
68 Installing and removing components