Dell EMC VxRail P470 - Installing the Network Daughter Card

Steps
1 Remove the expansion card riser 3.
2 Using a Phillips #2 screwdriver, loosen the two captive screws that secure the Network Daughter Card (NDC) to the system board.
3 Hold the NDC by the edges on either side of the touch points and lift to remove it from the connector on the system board.
4 Slide the NDC away from the back of the appliance until the Ethernet connectors are clear of the slot in the back panel.
5 Lift the NDC out of the appliance.
Figure 53. Removing the NDC
1
captive screw socket (2) 2 connector on the system board
3 captive screw (2) 4 touch point (2)
5 NDC 6 back panel slots for Ethernet connectors
Installing the network daughter card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your appliance section.
3 Keep the Philips #1 screwdriver handy.
NOTE
: If the appliance has three PCIe cards, ensure that you install the PCIe cooling shroud in your appliance.
96 Installing and removing components