Disabling a forgotten password
The software security features include a appliance password and a setup password. The password jumper enables the password features
or disables them and clears any passwords currently in use.
1 Turn off the appliance, including any attached peripherals, and disconnect the appliance from the electrical outlet.
2 Open the appliance.
3 Move the jumper on the system board jumper from pins 4 and 6 to pins 2 and 4.
4 Close the appliance.
The existing passwords are not disabled (erased) until the appliance boots with the jumper on pins 2 and 4. However, before you
assign a new appliancem and/or setup password, move the jumper back to pins 4 and 6.
NOTE: If you assign a new appliance and/or setup password with the jumper on pins 2 and 4, the appliance disables the
new passwords the next time it boots.
5 Reconnect the system board jumper to its electrical outlet and turn on the appliance, including any attached peripherals.
6 Turn off the appliance, including any attached peripherals, and disconnect the appliance from the electrical outlet.
7 Open the appliance.
8 Move the jumper on the system board jumper from pins 2 and 4 to pins 4 and 6.
9 Close the appliance.
10 Reconnect the appliance to its electrical outlet and turn on the appliance, including any attached peripherals.
11 Assign a new appliance and/or setup password.
Jumpers and connectors
129
To Next Page
Loading...
