a. Transmission image quality
Purpose:
To set the output quality.
Va lu e s:
Standard For documents with normal sized characters.
High Quality* For documents containing small characters or thin lines or documents printed using a dot-
matrix printer.
Super-high image quality For documents containing extremely fine detail. The super fine mode is enabled only if the
remote machine also supports Super Fine resolution. See the notes below.
* Denotes the factory default setting.
NOTE: Faxes printed in the Super-high image quality by Direct Fax driver transmits at the highest resolution supported by the
receiving device.
b. Transmission report
Purpose:
To specify whether to print a fax transmission result.
Va lu e s:
Output regularly Prints a transmission result after every fax transmission.
Output for non-transmission* Prints a transmission result only when an error occurs.
Do not output Does not print fax transmission results.
* Denotes the factory default setting.
c. Fax Cover Page
Purpose:
To specify whether to attach a cover page to your fax.
Va lu e s:
According to Printer Settings Determines whether to attach a cover page to your fax depending on the setting you specify in
Fax Cover Page on the operator panel.
Attach Attaches a cover page to your fax.
None* Does not attach a cover page to your fax.
* Denotes the factory default setting.
Sender
Purpose:
To specify whether to print the sender’s name on the fax cover page.
Va lu e s:
According to Printer Settings* Determines whether or not to print the sender’s name on the fax cover page based on the
printer settings.
Enter a sender name Allows you to enter a sender’s name that will be printed on the fax cover page in Sender
Name.
* Denotes the factory default setting.
382 Faxing
To Next Page
Loading...
