Dell C2665dnf - Verifying the IP Settings; Verifying the Settings Using Operator Panel; Verifying the Settings Using System Settings Report; Verifying the Settings Using Ping Command

Verifying the IP Settings
You can confirm the settings by using the operator panel, printing the system settings report, or using the ping
command.
Verifying the Settings Using Operator Panel
1 Press the (Information) button.
2 Ta p About This MFP .
3 Tap t h e Network tab.
4 Verify the IP address displayed in IP(v4) Address .
Verifying the Settings Using System Settings Report
1 Print the system settings report.
For details about how to print a system settings report, see "Report / List."
2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under
Network (Wired) or Network (Wireless) .
If the IP address shows
0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your
printer, see "Assigning an IP Address."
Verifying the Settings Using Ping Command
Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping
followed by the new IP address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you will receive a reply.
Setting the IP Address 73