3
Action Yes No
Adjust the transfer bias. The task is complete. Contact Dell.
a
On the operator panel, press the
(Information)
button and tap
the
Tools
tab
→
tap
Admin Settings→ Maintenance→
Adjust Transfer Belt Unit
.
b
Ta p
K Offset
or
YMC Offset
, and then decrease the value.
c
Launch the
Tool Box
, and click
Chart Print
on the
Diagnosis
tab.
d
Click
Ghost Configuration Chart
.
The Ghost Configuration Chart is printed.
Does this solve your problem?
Light-induced fatigue
Action Yes No
1 Check the light fatigue pattern using the Pitch Configuration Chart.
a
Launch the
Tool Bo x
, and click
Chart Print
on the
Diagnosis
tab.
b
Click
Pitch Configuration Chart
.
Go to action 2. Contact Dell.
The Pitch Configuration Chart is printed.
Does the pattern on the output match with that on the Pitch
Configuration Chart?
2 Replace the drum cartridges. See "Replacing the Drum Cartridges." The task is complete. Contact Dell.
Does this solve your problem?
Troubleshooting Guide
541
To Next Page
Loading...
