Open Shortest Path First (OSPFv2 and OSPFv3) | 1017
Command Modes
ROUTER OSPF
Command
History
Usage
Information
T
o specify a distance for routes learned from other routing domains, use the redistribute command.
distribute-list in
c e s
Apply a filter to incoming routing updates from OSPF to the routing table.
Syntax
distribute-list prefix-list-name in [interface]
To delete a filter, use the no distribute-list prefix-list-name in [interface] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command
History
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
prefix-list-name
Enter the name of a configured prefix list.
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
To Next Page
Loading...
