Open Shortest Path First (OSPFv2 and OSPFv3) | 1027
ip ospf transmit-delay
c e s
Set the estimated time elapsed to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
To return to the default value, enter no ip ospf transmit-delay.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
c e s
Generate a Syslog message for OSPF adjacency state changes. When enabled, changes are logged for
both IPv4 and IPv6 adjacencies.
Syntax
log-adjacency-changes
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
max-metric router-lsa
c e
Configure the maximum cost of 65535 on a new router so that it functions as a stub router in the
network and OSPF traffic destined to other networks is not forwarded on a path through the router.
Syntax
max-metric router-lsa [on-startup {announce-time | wait-for-bgp [wait-time]}]
To remove the maximum metric assignment from an OSPF router and send LSAs with the currently
configured cost, enter no max-metric router-lsa [on-startup {announce-time | wait-for-bgp
[wait-time]}].
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 8.4.1.0 Introduced for IPv6.
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
To Next Page
Loading...
