Dell Force10 TeraScale E Series - Page 1045

Open Shortest Path First (OSPFv2 and OSPFv3) | 1045
Related
Commands
show ip ospf database nssa-external
c e s
Display NSSA-External (type 7) LSA information.
Syntax
show ip ospf database nssa-external [link-state-id] [adv-router ip-address]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Related
Commands
show ip ospf database opaque-area
c e s
Display the opaque-area (type 10) LSA information.
Syntax
show ip ospf process-id database opaque-area [link-state-id] [adv-router ip-address]
Parameters
Command Modes
EXEC
show ip ospf database Displays OSPF database information.
link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID value depends
on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-address
(OPTIONAL) Enter the keywords
adv-router ip-address to display only the LSA
information about that router.
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
show ip ospf database Displays OSPF database information.
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID value depends
on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-address
(OPTIONAL) Enter the keywords
adv-router ip-address to display only the LSA
information about that router.