1046 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Example
Figure 38-13. Command Example: show ip ospf process-id database opaque-area
(Partial)
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Table 38-7. Command Example Descriptions: show ip ospf process-id database
opaque-area
Item Description
LS Age Displays the LSA’s age.
Options Displays the optional capabilities available on router. The following
options can be found in this item:
• TOS-capability or No TOS-capability is displayed depending on
whether the router can support Type of Service.
• DC or No DC is displayed depending on whether the originating router
can support OSPF over demand circuits.
• E or No E is displayed on whether the originating router can accept AS
External LSAs.
LS Type Displays the LSA’s type.
Link State ID Displays the Link State ID.
Advertising Router Identifies the advertising router’s ID.
Checksum Displays the Fletcher checksum of the an LSA’s complete contents.
Length Displays the length in bytes of the LSA.
FTOS>show ip ospf 1 database opaque-area
OSPF Router with ID (3.3.3.3) (Process ID 1)
Type-10 Opaque Link Area (Area 0)
LS age: 1133
Options: (No TOS-capability, No DC, E)
LS type: Type-10 Opaque Link Area
Link State ID: 1.0.0.1
Advertising Router: 10.16.1.160
LS Seq Number: 0x80000416
Checksum: 0x376
Length: 28
Opaque Type: 1
Opaque ID: 1
Unable to display opaque data
LS age: 833
Options: (No TOS-capability, No DC, E)
LS type: Type-10 Opaque Link Area
Link State ID: 1.0.0.2
Advertising Router: 10.16.1.160
LS Seq Number: 0x80000002
Checksum: 0x19c2
--More--
To Next Page
Loading...
