1084 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 38-29. show ipv6 ospf neighbor Command Example
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by the VLAN ID. The
range is from 1 to 4094.
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
FTOS#show ipv6 ospf neighbor gi 9/0
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Gi 9/0
FTOS#
To Next Page
Loading...
