Open Shortest Path First (OSPFv2 and OSPFv3) | 1083
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Example
Figure 38-28. show ipv6 ospf interface command
show ipv6 ospf neighbor
c e
Display the OSPF neighbor information on a per-interface basis.
Syntax
show ipv6 ospf neighbor [interface]
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to
4094
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
FTOS#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
FTOS#
To Next Page
Loading...
