1086 | Policy-based Routing (PBR)
www.dell.com | support.dell.com
description
c e s
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
REDIRECT-LIST
Command
History
Related
Commands
ip redirect-group
c e s
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an
interface by entering this command multiple times.
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-vl-)
Command
History
Usage
Information
Any number of redirect-groups can be applied to an interface. A redirect list can contain any number of
configured rules. These rules includes the next-hop IP address where the incoming traffic is to be
redirected.
description
Enter a description to identify the IP redirect list (80 characters maximum).
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
pre-Version 7.7.1.0 Introduced on the E-Series ExaScale
ip redirect-list Enable an IP Redirect List
redirect-list-name Enter the name of a configured redirect list.
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 7.4.2.0 Added support for LAG and VLAN interfaces
Version 6.5.3.0 Introduced on the E-Series ExaScale
To Next Page
Loading...
