Policy-based Routing (PBR) | 1087
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise the
normal routing table is used to forward traffic. When a redirect-group is applied to an interface and the
next-hop is reachable, the rules are added into the PBR CAM region. When incoming traffic hits an
entry in the CAM, the traffic is redirected to the corresponding next-hop IP address specified in the
rule.
Related
Commands
ip redirect-list
c e s
Configure a redirect list and enter the REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, enter no ip redirect-list.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Note: Apply redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr Display the content of the PBR CAM.
show ip redirect-list Display the redirect-list configuration.
redirect-list-name Enter the name of a redirect list.
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 6.5.3.0 Introduced on the E-Series ExaScale
To Next Page
Loading...
