Dell Force10 TeraScale E Series - Page 1154

1154 | Port Monitoring
www.dell.com | support.dell.com
Command
History
Usage
Information
To reconfigure destination ports in a remote-port mirroring session as untagged ports, enter the
untagged destination command.
Related
Commands
untagged destination
e
x
Configure destination ports for remote port mirroring so that the reserved VLAN tag is removed from
mirrored traffic sent to an analyzer.
Syntax
untagged destination {single-interface | range interface-range}
Parameters
Defaults
Destination ports send untagged packets to an analyzer so that the reserved VLAN ID is removed and
the original monitored packet is mirrored.
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Usage
Information
To configure destination ports in a remote-port mirroring session as tagged ports, enter the tagged
destination command.
Related
Commands
Version 8.4.1.2 Introduced on the E-Series ExaScale.
untagged
destination
Configure destination ports to remove the reserved VLAN tag from mirrored traffic.
single-interface
Specifies one of the following interface types:
• 1-Gigabit Ethernet: Enter gigabitethernet slot/port.
• 10-Gigabit Ethernet: Enter tengigabitethernet slot/port.
range
interface-range
Specifies one of the following interface ranges:
• gigabitethernet slot/first_port - last_port
• tengigabitethernet slot/first_port - last_port
A space is required before and after the dash (-).
For example:
untagged destination range gigabitethernet 1/2 - 4
Version 8.4.1.2 Introduced on the E-Series ExaScale.
tagged
destination
Configure destination ports to add the reserved VLAN tag to mirrored traffic.