Dell Force10 TeraScale E Series - Page 1198

1198 | Quality of Service (QoS)
www.dell.com | support.dell.com
configurations in per-queue output QoS policies are ignored. Scheduling and queuing configura-
tions (WRED and Bandwidth) in the per-queue output QoS policy still apply to each queue.
Related
Commands
policy-map-input
c e s
Create an input policy map.
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-name [layer2]
command.
Parameters
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
History
Usage
Information
Input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or
simply using incoming packets DSCP. This command enables policy-map-input configuration mode
(conf-policy-map-in).
Related
Commands
policy-map-output
c e s
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
policy-map-input Create an input policy map
policy-map-output Create an output policy map (E-Series Only)
policy-map-name
Enter the name for the policy map in character format (32 characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map.
Default: Layer 3
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Expanded to add support for Layer 2
pre-Version 6.1.1.1 Introduced on E-Series
service-queue Assign a class map and QoS policy to different queues.
policy-aggregate Allow an aggregate method of configuring per-port QoS via policy maps.
service-policy input Apply an input policy map to the selected interface.