Dell Force10 TeraScale E Series - Page 1203

Quality of Service (QoS) | 1203
Related
Commands
rate-limit
e
Specify the rate-limit functionality on outgoing traffic as part of the selected policy.
Syntax
rate-limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
Defaults
Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless the kbps option is used.
Command Modes
QOS-POLICY-OUT
Command
History
Related
Commands
show queue statistics ingress
Display the ingress queue statistics
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On
the E-Series, Dell Force10 recommends using a value greater than or equal
to 512 as lower values does not yield accurate results. The default
granularity is Megabits per second (Mbps).
Range: 0 to 10000000
committed-rate
Enter the committed rate in Mbps.
Range: 0 to 10000 Mbps
burst-KB
(OPTIONAL) Enter the burst size in KB.
Range: 16 to 200000 KB
Default: 50 KB
peak peak-rate
(OPTIONAL) Enter the keyword peak followed by the peak rate in Mbps.
Range: 0 to 10000 Mbps
Default: Same as designated for committed-rate
Version 8.2.1.0
Added
kbps option on E-Series.
Version 7.7.1.0 Removed from C-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate limit Specify rate-limit functionality on the selected interface.
qos-policy-output Create a QoS output policy.