1204 | Quality of Service (QoS)
www.dell.com | support.dell.com
rate-police
c e s
Specify the policing functionality on incoming traffic.
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
Defaults
Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless the kbps option is used.
Command Modes
QOS-POLICY-IN
Command
History
Related
Commands
rate-shape
c e s
Shape traffic output as part of the designated policy.
Syntax
rate-shape [kbps] rate [burst-KB]
Parameters
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On
C-Series and S-Series make the following value a multiple of 64. On the E-Series,
Dell Force10 recommends using a value greater than or equal to 512 as lower values
does not yield accurate results. The default granularity is Megabits per second
(Mbps).
Range: 0 to 10000000
committed-rate
Enter the committed rate in Mbps.
Range: 0 to 10000 Mbps
burst-KB
(OPTIONAL) Enter the burst size in KB.
Range: 16 to 200000 KB
Default: 50 KB
peak peak-rate
(OPTIONAL) Enter the keyword peak followed by the peak rate in Mbps.
Range: 0 to 10000 Mbps
Default: Same as designated for committed-rate
Version 8.2.1.0
Added
kbps option on C-Series, E-Series, and Series.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
rate police Specify traffic policing on the selected interface.
qos-policy-input Create a QoS output policy.
kbps
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On
C-Series and S-Series make the following value a multiple of 64. The default
granularity is Megabits per second (Mbps).
Range: 0-10000000
To Next Page
Loading...
