1414 | Storm Control
www.dell.com | support.dell.com
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control multicast (Configuration)
c s
Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series
networks only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control traffic may get
dropped when storm control thresholds are exceeded.
storm-control multicast (Interface)
c s
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress
only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Added percentage decimal value option
Version 6.5.1.0 Introduced on E-Series
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of multicast traffic
allowed into the network followed by the keyword
in.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on C-Series and S-Series only
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic
allowed into the network.
Range: 0 to 33554431
To Next Page
Loading...
