Dell Force10 TeraScale E Series - Page 1415

Storm Control | 1415
Command
History
storm-control unknown-unicast (Configuration)
c e s
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile
name]] [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast
[percentage decimal_value [in | out] | [wred-profile name]] [packets_per_second in]
command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
storm-control unknown-unicast (Interface)
c e s
Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
Syntax
storm-control unknown-unicast [percentage decimal_value in] | [wred-profile name]]
[packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control
unknown-unicast [percentage decimal_value in] | [wred-profile name]]
[packets_per_second in] command.
Version 7.6.1.0 Introduced on C-Series and S-Series
percentage
decimal_value [in |
out]
E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the
network. Optionally, you can designate a decimal value percentage, for
example, 55.5%.
Percentage: 0 to 100
0 % blocks all related traffic
100% allows all traffic into the interface
Decimal Range: 0.1 to 0.9
wred-profile name E-Series Only: (Optionally) Enter the keyword wred-profile followed by
the profile name to designate a wred-profile.
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic
allowed into the network.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Added percentage decimal value option
Version 6.5.1.0 Introduced on E-Series