C-Series Diagnostics and Debugging | 1497
hardware monitor linecard
e
Configure the system to take an action upon a line card hardware error.
Syntax
hardware monitor linecard asic {btm [action-on-error {card-problem | card-reset |
card-shutdown}] | fpc [action-on-error | parity-correction]}
Parameters
Defaults
None
Command Mode
CONFIGURATION
Command
History
hardware monitor mac
e
Configure the system to shut down all ports on a line card upon a MAC hardware error.
Syntax
hardware monitor mac action-on-error port-shutdown
Defaults
None
Command Mode
CONFIGURATION
Command
History
hardware watchdog
c
Set the watchdog timer to trigger a reboot and restart the system.
Syntax
hardware watchdog
Defaults
Enabled
action-on-error
Enter the keyword action-on-error to further specify actions that should be
taken in the event of a hardware error.
btm Enter the keyword btm to configure the system to take an action upon a Buffer
Traffic Manager hardware error.
fpc Enter the keyword fpc to configure the system to take an action upon a Flexible
Packet Classifier hardware error.
card-problem Enter the keyword card-problem to place a line card in a card-problem state
upon a hardware error.
card-reset Enter the keyword card-reset to reset a line card upon a hardware error.
card-shutdown Enter the keyword card-shutdown to shutdown a line card upon a hardware
error.
parity-correction Enter the keyword parity-correction to enable automatic parity corrections for
SRAM. The line card must be reloaded before the feature becomes operational.
Version 8.2.1.0 Introduced
Version 8.2.1.0 Introduced
To Next Page
Loading...
