1498 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Command Mode
CONFIGURATION
Command
History
Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS switch/
router with a single unresponsive RPM. This is a last resort mechanism intended to prevent a manual
power cycle.
show hardware cpu party-bus
c
View advanced debugging counters for the party-bus port on the CPU of the specified line card or
RPM.
Syntax
show hardware {linecard | rpm} number cpu party-bus statistics
Parameters
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
Version 7.7.1.0 Introduced
linecard Enter the keyword linecard to view debugging counters for a
line card.
rpm Enter the keyword rpm to view cpu debugging counters for an
RPM.
number
Enter a number after the following keywords:
• After the keyword
rpm:
Range: 0-1
• After the keyword
linecard:
Range: 0-7 for the C300
Version 7.5.1.0 Introduction
To Next Page
Loading...
