156 | Control and Monitoring
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
host
Enter the name of a server.
ip-address
Enter the IPv4 address in dotted decimal format of the server.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the
/x format.
Range: /0 to /128
Note: The
:: notation specifies successive hexadecimal fields of zeros
vrf instance (Optional) E-Series Only: Enter the keyword vrf followed by the VRF Instance
name.
source-interface (OPTIONAL) Enter the keywords /source-interface followed by the
interface information to include the interface’s IP address.
Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from zero (0) to 16383.
• For the Null interface, enter the keyword
null followed by 0.
• For a Port Channel interface, enter the keyword
port-channel followed by
a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For SONET interface types, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1
to 4094.
To Next Page
Loading...
