Dell Force10 TeraScale E Series - Page 200

200 | 802.1X
www.dell.com | support.dell.com
show dot1x cos-mapping interface
c s
Display the CoS priority-mapping table provided by the RADIUS server and applied to authenticated
supplicants on an 802.1X-enabled port.
Syntax
show dot1x cos-mapping interface interface [mac-address mac-address]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC privilege
Command
History
Usage
Information
Enter a supplicant’s MAC address using the mac-address option to display CoS mapping
information only for the specified supplicant.
You can display the CoS mapping information applied to traffic from authenticated supplicants on
802.1X-enabled ports that are in single-host, multi-host, and multi-supplicant authentication modes.
Example
Figure 8-1. show dot1x cos-mapping interface Command Example
interface
Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
mac-address
(Optional) MAC address of an 802.1X-authenticated supplicant.
Version 8.4.2.1 Introduced on the C-Series and S-Series
FTOS#show dot1x cos-mapping interface gigabitehternet 2/21
802.1p CoS re-map table on Gi 2/21:
----------------------------------
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
FTOS#show dot1x cos-mapping int g 2/21 mac-address 00:00:01:00:07:00
802.1p CoS re-map table on Gi 2/21:
----------------------------------
802.1p CoS re-map table for Supplicant: 00:00:01:00:07:00
Dot1p Remapped Dot1p
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0