208 | Access Control Lists (ACL)
www.dell.com | support.dell.com
c and s platforms support Ingress IP ACLs only.
The following commands allow you to clear, display, and assign IP ACL configurations.
• access-class
• clear counters ip access-group
• ip access-group
• show ip access-lists
• show ip accounting access-list
access-class
c e s
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name
Parameters
Defaults
Not configured.
Command Modes
LINE
Command
History
clear counters ip access-group
c e s
Erase all counters maintained for access lists.
Syntax
clear counters ip access-group [access-list-name]
Parameters
Command Modes
EXEC Privilege
Command
History
Note: See also Commands Common to all ACL Types.
access-list-name
Enter the name of a configured Standard ACL, up to 140 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up
to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up
to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced
To Next Page
Loading...
