Access Control Lists (ACL) | 215
Command
History
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. See the “Quality of
Service” chapter of the FTOS Configuration Guide for more information.
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
The monitor option is relevant in the context of flow-based monitoring only. See Chapter 44, Port
Monitoring.
The C-Series and S-Series cannot count both packets and bytes, so when you enter the count byte
options, only bytes are incremented.
Related
Commands
resequence access-list
c e s
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum
Step-to-Increment}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Version 8.3.1.0 Add DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 7.4.1.0
Added support for non-contiguous mask and added the
monitor option.
Version 6.5.10
Expanded to include the optional QoS
order priority for the ACL entry.
Note: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
deny Assign a IP ACL filter to deny IP packets.
ip access-list standard Create a standard ACL.
ipv4 | ipv6 | mac Enter the keyword ipv4, or mac to identify the access list type to
resequence.
access-list-name
Enter the name of a configured IP access list.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 0 - 4294967290
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 - 4294967290
To Next Page
Loading...
