Dell Force10 TeraScale E Series - Page 216

216 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
number to entries of an existing access-list.
Related
Commands
resequence prefix-list ipv4
c e s
Re-assign sequence numbers to entries of an existing prefix list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-increment}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
number to entries of an existing prefix list.
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.4.1.0 Introduced
resequence prefix-list ipv4 Resequence a prefix list
prefix-list-name
Enter the name of configured prefix list, up to 140 characters long.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 0 – 65535
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 – 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
resequence access-list Resequence an access-list