Dell Force10 TeraScale E Series - Page 243

Access Control Lists (ACL) | 243
Related
Commands
resequence access-list
c e s
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name StartingSeqNum
Step-to-Increment}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
number to entries of an existing access-list.
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
resequence prefix-list ipv4
c e s
Re-assign sequence numbers to entries of an existing prefix list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum Step-to-increment}
ip access-list extended Configure an extended ACL.
permit Assign a permit filter for IP packets.
permit tcp Assign a permit filter for TCP packets.
ipv4 | mac Enter the keyword ipv4, or mac to identify the access list type to resequence.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 0 - 4294967290
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 - 4294967290
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 7.4.1.0 Introduced for E-Series
resequence prefix-list ipv4 Resequence a prefix list