Dell Force10 TeraScale E Series - Page 273

Access Control Lists (ACL) | 273
match ip address
c e s
Configure a filter to match routes based on IP addresses specified in an access list.
Syntax
match ip address prefix-list-name
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match ip next-hop
c e s
Configure a filter to match based on the next-hop IP addresses specified in an IP access list or IP prefix
list.
Syntax
match ip next-hop {access-list | prefix-list prefix-list-name}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
match route-type Redistribute routes that match a route type.
match tag Redistribute routes that match a specific tag.
prefix-list-name
Enter the name of configured prefix list, up to 140 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
match tag Redistribute routes that match a specific tag.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
prefix-list
prefix-list-name
Enter the keywords prefix-list followed by the name of configured prefix
list.