Dell Force10 TeraScale E Series - Page 292

292 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured
Command Modes
COMMUNITY-LIST
Command
History
show config
e
Display the non-default information in the current configuration.
Syntax
show config
Command Mode
COMMUNITY-LIST
Command
History
Example
Figure 9-19. Command Example: show config (COMMUNITY-LIST
no-export Enter the keywords no-export to drop all routes containing the well-known
community attribute of NO_EXPORT.
All routes with the NO_EXPORT (0xFFFFFF01) community attribute must not be
advertised outside a BGP confederation boundary.
regexp
regular-expression
Enter the keyword regexp followed by a regular expression. Use one or a
combination of the following:
• . = (period) matches on any single character, including white space
• * = (asterisk) matches on sequences in a pattern (zero or more sequences)
• + = (plus sign) matches on sequences in a pattern (one or more sequences)
• ? = (question mark) matches sequences in a pattern (0 or 1 sequences). You must
enter an escape sequence (CNTL+v) prior to entering the ? regular
expression.
• [] = (brackets) matches a range of single-character patterns.
• ^ = (caret) matches the beginning of the input string. (If the caret is used at the
beginning of a sequence or range, it matches on everything BUT the characters
specified.)
• $ = (dollar sign) matches the end of the output string.
• _ = (underscore) matches a comma (,), left brace ({), right brace (}), left
parenthesis, right parenthesis, the beginning of the input string, the end of the
input string, or a space.
• | = (pipe) matches either character.
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series
FTOS(config-std-community-list)#show config
!
ip community-list standard patches
deny 45:1
permit no-export
FTOS(config-std-community-list)#