Dell Force10 TeraScale E Series - Page 344

344 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
neighbor default-originate
c e s
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate [route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-group-name}
default-originate command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
configured, the software does not apply the set filters in the route map to that BGP peer or neighbor.
Command
History
neighbor description
c e s
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name} description
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the default route of all routers in that peer
group.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
text
Enter a continuous text string up to 80 characters.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series