Dynamic Host Configuration Protocol (DHCP) | 459
Parameters
Command Mode
EXEC Privilege
Default
None
Command
History
default-router
c s
Assign a default gateway to clients based on address pool.
Syntax
default-router address [address2...address8]
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
disable
c s
Disable DHCP Server.
DHCP Server is disabled by default. Enable the system to be a DHCP server using the no form of the
disable command.
Syntax
disable
Command Mode
CONFIGURATION
Default
Disabled
Command
History
dns-server
c s
Assign a DNS server to clients based on address pool.
Syntax
dns-server address [address2...address8]
events
Enter this keyword to display DHCP state changes.
packet
Enter this keyword to display packet transmission/reception.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address
Enter the a list of routers that may be the default gateway for clients on the subnet. You may
specify up to 8. List them in order of preference.
Version 8.2.1.0 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on C-Series and S-Series.
To Next Page
Loading...
