460 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
domain-name
c s
Assign a domain to clients based on address pool.
Syntax
domain-name name
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
excluded-address
c s
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
Command Mode
DHCP
Default
None
Command
History
hardware-address
c s
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
address
Enter the a list of DNS servers that may service clients on the subnet. You may list up to 8
servers, in order of preference.
Version 8.2.1.0 Introduced on C-Series and S-Series.
name
Give a name to the group of addresses in a pool.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address
Enter a single address to be excluded from the pool.
low-address
Enter the lowest address in a range of addresses to be excluded from the pool.
high-address
Enter the highest address in a range of addresses to be excluded from the pool.
Version 8.2.1.0 Introduced on C-Series and S-Series.
To Next Page
Loading...
