Dell Force10 TeraScale E Series - Page 461

Dynamic Host Configuration Protocol (DHCP) | 461
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
host
c s
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
ip dhcp bootp
c s
Allow the DHCP server to respond to BOOTP messages, or direct the server to ignore them.
Syntax
ip dhcp bootp [automatic | ignore]
Parameters
Command Mode
DHCP
Default
automatic
Command
History
ip dhcp relay information
c s
Syntax
ip dhcp relay information [check | option | policy]
Parameters
address
Enter the hardware address of the client.
Version 8.2.1.0 Introduced on C-Series and S-Series.
address/mask
Enter the host IP address and subnet mask.
Version 8.2.1.0 Introduced on C-Series and S-Series.
automatic
Enter this keyword to instruct the server to respond to BOOTP messages.
ignore
Enter this keyword to instruct the server to ignore all BOOTP messages.
Version 8.2.1.0 Introduced on C-Series and S-Series.
check