Dell Force10 TeraScale E Series - Page 463

Dynamic Host Configuration Protocol (DHCP) | 463
netbios-node-type
c s
Specify the NetBIOS node type for a Microsoft DHCP client. Dell Force10 recommends specifying
clients as hybrid.
Syntax
netbios-node-type type
Parameters
Command Mode
DHCP <POOL>
Default
Hybrid
Command
History
network
c s
Specify the range of addresses in an address pool.
Syntax
network network /prefix-length
Parameters
Command Mode
DHCP <POOL>
Default
None
Command
History
pool
c s
Create an address pool
Syntax
pool name
Parameters
Command Mode
DHCP
Default
None
Command
History
type
Enter the NETBIOS node type.
Broadcast: Enter the keyword b-node.
Hybrid: Enter the keyword h-node.
Mixed: Enter the keyword m-node.
Peer-to-peer: Enter the keyword p-node.
Version 8.2.1.0 Introduced on C-Series and S-Series.
network/
prefix-length
Specify a range of addresses.
Prefix-length Range: 17-31
Version 8.2.1.0 Introduced on C-Series and S-Series.
name
Enter the address pool’s identifying name
Version 8.2.1.0 Introduced on C-Series and S-Series.