Dell Force10 TeraScale E Series - Page 486

486 | FTOS Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
clear frrp
c e
Clear the FRRP statistics counters.
Syntax
clear frrp [ring-id]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 18-1. clear frrp Command Examples
Usage
Information
Executing this command, without the optional ring-id, will clear statistics counters on all the available
rings. FTOS requires a command line confirmation before the command is executed. This commands
clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Related
Commands
debug frrp
c e
Enable FRRP debugging.
Syntax
debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail} {ring-id} [count number]
command.
ring-id
(Optional) Enter the ring identification number.
Range: 1 to 255
Version 8.2.1.0 Introduced for the C-Series
Version 7.5.1.0 Introduced
FTOS#clear frrp
Clear frrp statistics counter on all ring [confirm] yes
FTOS#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
FTOS#
clears the frrp counters for all the available rings
confirmation required
clears the frrp counters on the specified ring
confirmation required
show frrp Display the Resilient Ring Protocol configuration