Dell Force10 TeraScale E Series - Page 52

52 | File Management
www.dell.com | support.dell.com
S-Series Example
Command output example on an S50V: show version
upgrade (E-Series version)
e
Upgrade the bootflash, boot selector, or system image on a processor.
Syntax
upgrade {bootflash-image | bootselector-image | system-image} {all | linecard
linecard-slot | rpm} {booted | file-url}
Parameters
128K bytes... Amount and type of memory on system.
1 Route Processor... Hardware configuration of the system, including the number and type of
physical interfaces available.
show version Command Fields
Lines beginning with Description
FTOS#show version
Force10 Networks Real Time Operating System Software
Force10 Operating System Version: 1.0
Force10 Application Software Version: E7-8-1-13
Copyright (c) 1999-2008 by Force10 Networks, Inc.
Build Time: Mon Nov 24 18:59:27 2008
Build Path: /sites/sjc/work/sw/build/build2/Release/E7-8-1/SW/SRC
Force10 uptime is 1 minute(s)
System Type: S50V
Control Processor: MPC8451E with 252739584 bytes of memory.
32M bytes of boot flash memory.
1 48-port E/FE/GE with POE (SB)
48 GigabitEthernet/IEEE 802.3 interface(s)
4 Ten GigabitEthernet/IEEE 802.3 interface(s)
FTOS#
bootflash-image Enter the keyword bootflash-image to upgrade the bootflash image.
bootselector-image Enter the keyword bootselector-image to upgrade the boot selector
image.
Use with TAC supervision only.
system-image Enter the keyword system-image to upgrade the cache boot image.
all Enter the keyword all to upgrade the bootflash/boot selector image on all
processors in the E-Series. This keyword does not upgrade the bootflash on
the standby RPM.
linecard linecard-slot Enter the keyword linecard followed by the slot number to change the
bootflash image on a specific line card.
E-Series Range: 0 to 13 on the E1200; 0 to 6 for the E600; 0 to 5 on the
E300
rpm Enter the keyword rpm to upgrade the bootflash/boot selector image on all
processors on the RPM.