Dell Force10 TeraScale E Series - Page 53

File Management | 53
Defaults
No configuration or default values
Command Modes
EXEC Privilege
Command
History
Usage
Information
A system message appears stating the Bootflash upgrade status. Reload the system to boot from the
upgraded boot images.
Once the URL is specified, the same downloaded image can be used for upgrading an individual RPM,
line cards, SFM FPGA, and system-image for cache-boot without specifying the file-url again using
the command upgrade {bootflash-image | bootselector-image | system-image} {all |
linecard linecard-slot | rpm}. After 20 minutes, the cached memory is released and returned for
general use, but the URL is maintained and you do not have to specify it for subsequent upgrades.
Related
Commands
upgrade (C-Series version)
c
Upgrade the bootflash or boot selector image on a processor.
Syntax
upgrade {bootflash-image | bootselector-image | system-image}
{all | linecard {number | all} | rpm} [booted | file-url | repair]
Parameters
booted
Enter this keyword to upgrade using the image packed with the currently
running FTOS image.
file-url
Enter the following location keywords and information to upgrade using an
FTOS image other than the one currently running:
Enter the transfer method and file location:
flash://filename
ftp://userid
:password@hostip/filepath
slot0://filename
tftp://hostip
/filepath
Version 7.7.1.0
Removed
alt-bootflash-image, alt-bootselector-image,
alt-system-image options, rp1, rp2, and cp options.
E-Series original Command
upgrade fpga-image
Upgrade the FPGA version in the specified E-Series SFM.
boot system
Display configured boot image information
bootflash-image Enter the keyword bootflash-image to upgrade the bootflash image.
bootselector-image Enter the keyword bootselector-image to upgrade the boot selector
image. Use with TAC supervision only.
system-image Enter the keyword system-image to upgrade the system image. Use
with TAC supervision only.
all Enter the keyword all to upgrade the bootflash or boot selector image on
all processors. This keyword does not upgrade the bootflash on the standby
RPM.
Enter the keyword all after the keyword linecard to upgrade the
bootflash or boot selector image on all linecards.