Dell Force10 TeraScale E Series - Page 527

GARP VLAN Registration (GVRP) | 527
clear gvrp statistics
c e s
Clear GVRP statistics on an interface.
Syntax
clear gvrp statistics interface interface
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Related
Commands
debug gvrp
c e s
Enable debugging on GVRP.
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu} command.
Parameters
interface interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 7.6.1.0 Introduced on C, E, and S-Series
show gvrp statistics Display the GVRP statistics
config Enter the keyword config to enable debugging on the GVRP configuration.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port
or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.