Dell Force10 TeraScale E Series - Page 532

532 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 20-2. show gvrp brief Command Example
Usage
Information
If no ports are GVRP participants, the message output changes from:
GVRP Participants running on <port_list>
to
GVRP Participants running on no ports
Related
Commands
show gvrp statistics
c e s
Display the GVRP configuration statistics.
Syntax
show gvrp statistics {interface interface | summary}
brief (OPTIONAL) Enter the keyword brief to display a brief summary of the GVRP
configuration.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version7.6.1.0 Introduced on C, E, and S-Series
R3#show gvrp brief
GVRP Feature is currently enabled.
Port GVRP Status Edge-Port
-------------------------------------------------------
Gi 3/0 Disabled No
Gi 3/1 Disabled No
Gi 3/2 Enabled No
Gi 3/3 Disabled No
Gi 3/4 Disabled No
Gi 3/5 Disabled No
Gi 3/6 Disabled No
Gi 3/7 Disabled No
Gi 3/8 Disabled No
R3#show gvrp brief
show gvrp statistics Display the GVRP statistics