Dell Force10 TeraScale E Series - Page 568

568 | Interfaces
www.dell.com | support.dell.com
duplex (Management)
c e
Set the mode of the Management interface.
Syntax
duplex {half | full}
To return to the default setting, enter no duplex.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies only to the Management interface on the RPMs.
Related
Commands
duplex (10/100 Interfaces)
c e s
Configure duplex mode on any physical interfaces where the speed is set to 10/100.Syntax
duplex {half | full}
To return to the default setting, enter no duplex.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
half Enter the keyword half to set the Management interface to transmit only in one direction.
full Enter the keyword full to set the Management interface to transmit in both directions.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Documentation modified—added Management to distinguish from duplex (10/100
Interfaces)
interface ManagementEthernet
Configure the Management port on the system (either the Primary
or Standby RPM).
duplex (Management)
Set the mode of the Management interface.
management route Configure a static route that points to the Management interface or a
forwarding router.
speed (Management interface)
Set the speed on the Management interface.
half Enter the keyword half to set the physical interface to transmit only in one direction.
full Enter the keyword full to set the physical interface to transmit in both directions.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Introduced