Dell Force10 TeraScale E Series - Page 598

598 | Interfaces
www.dell.com | support.dell.com
show interfaces dampening
c e s
Display interface dampening information.
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 23-33. show interfaces dampening Command Example
Related
Commands
interface
(Optional) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
summary (OPTIONAL) Enter the keyword summary to display the current
summary of dampening data, including the number of interfaces configured
and the number of interfaces suppressed, if any.
detail (OPTIONAL) Enter the keyword detail to display detailed interface
dampening data.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced
FTOS#show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Gi 3/2 Up 0 0 20 800 4500 120
Gi 3/10 Up 0 0 5 750 2500 20
FTOS#
dampening Configure dampening on an interface
show interfaces Display information on a specific physical interface or virtual interface.
show interfaces configured Display any interface with a non-default configuration.