Interfaces | 601
show interfaces linecard
c e
Display information on all interfaces on a specific line card.
Syntax
show interfaces linecard slot-number
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
The following figure shows a line card that has an XFP interface. The type, medium, wavelength, and
receive power details are displayed. When a device that is not certified by Dell Force10 is inserted, it
might work, but its details might not be readable by FTOS and not displayed here.
Example
Figure 23-35. show interfaces linecard Command Example (in C150)
Related
Commands
slot-number
Enter a number for the line card slot.
C-Series Range: 0-7 for C300; 0–3 for C150
E-Series Range: 0 to 13 on the E1200/1200i, 0 to 6 on the E600/600i, 0 to 5 on the
E300
Version 8.1.1.2 Introduced support on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS#show interfaces linecard 0
TenGigabitEthernet 0/0 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:51:b2:d4
Current address is 00:01:e8:51:b2:d4
Pluggable media present, XFP type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850.00nm
XFP receive power reading is -2.3538
Interface index is 33883138
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 20:16:29
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
--More--
show interfaces Display information on a specific physical interface or virtual interface.
To Next Page
Loading...
