Dell Force10 TeraScale E Series - Page 606

606 | Interfaces
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 23-39. show interfaces switchport Command Example
interface
Enter one of the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For SONET interfaces, enter the keyword
sonet followed by the slot/port
information. This keyword is only available on E-Series and C-Series.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• Enter the keyword
backup to view the backup interface for this interface.
linecard
slot-number
(OPTIONAL) Enter the keyword linecard followed by the slot number. This option is
available only on E-Series and C-Series.
C-Series Range: 0-7 for C300; 0–3 for C150
E-Series Range: 0 to 13 on the E1200, 0 to 6 on the E600, 0 to 5 on the E300
stack-unit
unit-id
(OPTIONAL) Enter the keyword stack-unit followed by the stack member number.
This option is available only on S-Series.
Range: 0 to 1
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for hybrid port/native VLAN, introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
FTOS#show interfaces switchport
Name: GigabitEthernet 13/0
802.1QTagged: Hybrid
Vlan membership:
Vlan 2, Vlan 20
Native VlanId: 20
Name: GigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: GigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: GigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
--More--