Dell Force10 TeraScale E Series - Page 605

Interfaces | 605
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 23-38. show interfaces status Command Example
Related
Commands
show interfaces switchport
c e s
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2
mode interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface [linecard slot-number] | stack-unit unit-id ]
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series
FTOS#show interfaces status
Port Description Status Speed Duplex Vlan
Gi 0/0 Up 1000 Mbit Auto --
Gi 0/1 Down Auto Auto 1
Gi 0/2 Down Auto Auto 1
Gi 0/3 Down Auto Auto --
Gi 0/4 Force10Port Up 1000 Mbit Auto 30-130
Gi 0/5 Down Auto Auto --
Gi 0/6 Down Auto Auto --
Gi 0/7 Up 1000 Mbit Auto 1502,1504,1506-1508,1602
Gi 0/8 Down Auto Auto --
Gi 0/9 Down Auto Auto --
Gi 0/10 Down Auto Auto --
Gi 0/11 Down Auto Auto --
Gi 0/12 Down Auto Auto --
Gi 0/13 Down Auto Auto --
Gi 0/14 Down Auto Auto --
Gi 0/15 Down Auto Auto --
FTOS#
show interfaces Display information on a specific physical interface or virtual interface.