Dell Force10 TeraScale E Series - Page 636

636 | IPv4 Routing
www.dell.com | support.dell.com
clear host
c e s
Remove one or all dynamically learnt host table entries.
Syntax
clear host name
Parameters
Command Modes
EXEC Privilege
Command
History
clear ip fib linecard
c e s
Clear all Forwarding Information Base (fib) entries in the specified line card (use this command with
caution, see Usage Information below)
Syntax
clear ip fib linecard slot-number | vrf vrf instance
Parameters
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
Use this command to clear Layer 3 CAM inconsistencies.
Related
Commands
name
Enter the name of the host to delete.
Enter * to delete all host table entries.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
slot-number
Enter the number of the line card slot.
C-Series and S-Series Range: 0-7
E-Series Range: 0 to 13 on E12001200i, 0 to 6 on E600/E600i; 0 to 5 on E300
vrf instance
(Optional) E-Series Only: Clear only the FIB entries on the specified card
associated with the VRF instance.
Version 8.1.1.2 Introduced support on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.9.1.0 Introduced VRF on the E-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Caution: Executing this command will cause traffic disruption.
show ip fib linecard
Show FIB entries.