Dell Force10 TeraScale E Series - Page 673

IPv4 Routing | 673
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 24-20. show ip route all Command Example
Example
Figure 24-21. show ip route summary and show ip route static Command Examples
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.9.1.0 Introduced VRF on the E-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show ip route all
Codes: C - connected, S - static, R - RIP
B - BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated
O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default
> - non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12
via 101.10.10.10, So 2/9
C 100.10.10.0/24 Direct, So 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, So 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, So 2/9 0/0 00:09:15
> R 101.10.10.0/24 Direct, So 2/9 120/0 00:09:15
FTOS#
FTOS#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
R1_E600i>show ip route static ?
| Pipe through a command
<cr>
R1_E600i>show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Gi 1/2 1/0 3d2h
FTOS>